3Com Router Command Reference Guide — V1.00data message that conforms to the address access control list by configuring thecorrelation between the address control list and the interface. To translate byselecting one address in the address pool or by using the IP address of the interfacedirectly, you can configure different address translation correlation on one interface.Example# The host computers of the 10.110.10.0/24 network segment are allowed foraddress translation, selecting the addresses from 202.110.10.10 to 202.110.10.12 asthe translated address. Assume that ISP is connected by Serial0 port.[Quidway]acl 1[Quidway-acl-1]rule permit source 10.110.10.0 0.0.0.255# Add correlation between the address list and the address pool.[Quidway-Serial0] nat outbound 1 interface2.6.8 nat resetSyntaxnat resetViewInterface viewParameterNoneDescriptionUsing the nat reset command, you can reset NAT mapping table.ExampleNone2.6.9 nat serverSyntaxnat server global global-addr { global-port | any | domain | ftp | pop2 | pop3 | smtp| telnet | www } inside inside-addr { inside-port | any | domain | ftp | pop2 | pop3 |smtp | telnet | www } { protocol-number | ip | icmp | tcp | udp }46
