3Com Router Command Reference Guide — V1.00half-life-unreachable: Half life when the route becomes unreachable, ranging from 1to 45 minutes; 15 minutes by default.reuse: Lower time threshold, ranging from 1 to 20000; 750 seconds by default. If thepenalty is lower than this time, the route will be reused.suppress: Upper time threshold, ranging from 1 to 20000, 2000 seconds by default. Ifthe penalty is higher than this threshold, the route will be suppressed,ceiling: The Max. time limit of suppression, ranging from 1 to 20000. 1600 seconds bydefault.policy-name: Configure route policy name.DescriptionUsing the Dampening command, you can put BGP route attenuation in effect ormodify the BGP route attenuation parameter. Using the undo dampening command,you can cancel the configured route attenuation.If no parameters are configured in this command, then BGP route dampening is valid,and the parameters take default values. The parameters are mutually dependent.Once any parameter is configured, all other parameters should also be specified.For related commands, see reset dampening, reset bgp flap-information, displaybgp routing-table dampened, display bgp routing-table flap-information.Example# Configure the parameters of BGP routing dampening.[3Com-bgp] dampening 15 15 1000 2000 100004.1.8 debugging bgpSyntaxdebugging bgp { all | event | { keepalive | open | packet | update } [ receive |send ] [ verbose ] } }undo debugging bgp { all | event | keepalive | open | packet | update }ViewAll viewsParameterall: Enable all kinds of bgp debugging switch.74
