116 | System Configuration Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o minlinepower priorityConfigure the priority of a port in terms of access to power.Syntax inlinepower priority {critical | high | low}ParametersDefaults By default, the power priority of a port is set to low.Mode Interface Config; Interface Range EthernetCommandHistoryRelatedCommandsinlinepower limitConfigure the power limit of a port (the number of watts available to it if PoE is enabled and otherports do not have higher priority access to the power budget).Syntax inlinepower limit 1-18ParametersDefaults 18 (18 watts)Mode Interface Config; Interface Range EthernetCommandHistoryRelatedCommandsinlinepower typeEnter a power profile description of the port.Syntax inlinepower type type-stringcritical | high | low Enter critical to enable the selected port to receive power at the highestpriority.Enter high to enable the selected port to receive power at the next highestpriority.Enter low to set the power priority of the selected port at the lowest level.Version 2.5.1 Introducedshow inlinepower (stack) Display PoE status of stack members.show inlinepower Display PoE status of designated port.1-18 Enter an integer from 1 to 18, representing the maximum number of watts tomake available to the selected port.Version 2.5.1 Introducedshow inlinepower (stack) Display PoE status of stack members.show inlinepower Display PoE status of designated port.