486 | PIM Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mip pimdm modeThis command sets administrative mode of PIM-DM on an interface to enabled.Syntax [no] aduda,.,u,e.E unit/slot/portThe no version of this command sets administrative mode of PIM-DM on an interface to disabled.Default disabledMode Interface Config or Interface VLAN; Interface Range, which is indicated by the(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.CommandHistoryip pimdm query-intervalThis command configures the transmission frequency of hello messages between PIM enabledneighbors. This field has a range of 10 to 3600 seconds.Syntax ip pimdm query-interval secondsno ip pimdm query-intervalThe no version of this command resets the transmission frequency of hello messages between PIMenabled neighbors to the default value.Default 30Mode Interface Config or Interface VLAN; Interface Range, which is indicated by the(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.CommandHistoryshow ip pimdmThis command displays the system-wide information for PIM-DM.Version 2.5.2 Unsupported: not tested in 2.5.2Version 2.5.1 Unsupported: not tested in 2.5.1Version 2.3 Added Interface Range and Interface VLAN modes.RelatedCommandsinterface range Defines an interface range and accesses the Interface Range modeinterface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.Version 2.5.2 Unsupported: not tested in 2.5.2Version 2.5.1 Unsupported: not tested in 2.5.1Version 2.3 Added Interface Range and Interface VLAN modes.RelatedCommandsinterface range Defines an interface range and accesses the Interface Range modeinterface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode.