160 | Link Layer Discovery Protocol (LLDP) Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mlldp helloUse this command to set the interval, in seconds, to transmit local LLDP data (LLDPDUs).Syntax lldp hello intervalRange: 1-180 secondsDefault 30 secondsThe hello is automatically enabled when the lldp mode command is executed in either the global orinterface mode. If you change the interval value to a non-default value, it takes effect immediately.Then, if you disable LLDP, the value resets to the default.Mode Global ConfigCommandHistorylldp mode (global)Enable LLDP on the switch.Syntax [no] lldp mode {tx | rx | both}Default Not enabled; when enabled, both is the default.Mode Global ConfigRelatedCommands clear lldp neighbors Clear LLDP neighbor information.lldp mode (global) Enable/disable LLDP globally.lldp mode (interface) Enable/disable LLDP on a particular interface.show lldp local-device Display LLDP neighbor information.Version 2.5.1 IntroducedRelatedCommands lldp mode (interface) Enable/disable LLDP on an interface.lldp mode (global) Enable/disable LLDP globally.lldp timers-reinit Configure LLDP global timer for delay before re-initialization.lldp multiplier The interval multiplier to set local LLDP data TTLlldp notification-interval Minimum interval to send remote data change notificationsshow lldp local-device Display LLDP neighbor information.Parameters tx Enable/Disable LLDP transmit capability.rx Enable/Disable LLDP receive capability.both Enable/Disable LLDP both transmit and receive capabilities.
