58 | System Management Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mRelatedCommandsJava Mode Enable or Disable. Specifies if the switch should allow access to the Javaapplet in the header frame. Enabled means the applet can be viewed. Thefactory default is disabled.Locally Administered MACAddressIf desired, a locally administered MAC address can be configured forin-band connectivity. To take effect, 'MAC Address Type' must be set to'Locally Administered'. Enter the address as twelve hexadecimal digits (6bytes) with a colon between each byte. Bit 1 of byte 0 must be set to a 1 andbit 0 to a 0, i.e. byte 0 should have the following mask 'xxxx xx10'. TheMAC address used by this bridge when it must be referred to in a uniquefashion. It is recommended that this be the numerically smallest MACaddress of all ports that belong to this bridge. However it is only required tobe unique. When concatenated with dot1dStpPriority a uniqueBridgeIdentifier is formed which is used in the Spanning Tree Protocol.MAC Address Type Specifies which MAC address should be used for in-band connectivity. Thechoices are the burned in or the Locally Administered address. The factorydefault is to use the burned in MAC address.Management VLAN ID Specifies the management VLAN ID.Network Configuration ProtocolCurrentIndicates which network protocol is being used. The options are bootp |dhcp | none.Web Mode Enable or DisableTable 5-9. Fields in Output of show interface managementethernet commandField Descriptionip address (management) Configures the IP address of the management interface.show ethernet Displays statistics for a specific port or for the switch.show interface Displays statistics for a specific port.show interface switchport Displays a summary of statistics on Layer 2 interfaces.show interface ethernet Displays detailed statistics for a specific ethernet port or for all CPU trafficbased upon the argument.show interfaces Displays information about a selected interface or VLAN
