474 | IP Multicast Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m CommandHistoryip igmp query-max-resp-timeThis command configures the maximum response time interval for the specified interface or VLAN,which is the maximum query response time advertised in IGMPv2 queries on this interface or VLAN.Syntax ip igmp query-max-response-time 0-255To reset the maximum response time interval for the specified interface to the default value of 100tenths of a second, use the no ip igmp query-max-response-time command.Default 100 tenths of a secondMode Interface Config; Interface VLANCommandHistoryip igmp robustnessThis command configures the robustness that allows tuning of the interface or VLAN. The robustnessis the tuning for the expected packet loss on a subnet. If a subnet is expected to have a lot of loss, therobustness variable may be increased for the interface or VLAN.Syntax ip igmp robustness robustnessThe range for robustness is 1 to 255.The no ip igmp robustness command sets the robustness value to the default.Default 2Mode Interface Config; Interface VLANCommandHistoryip igmp startup-query-countThis command sets the number of Queries sent out on startup, separated by the Startup Query Intervalon the interface or VLAN.Syntax ip igmp startup-query-count countVersion 2.3 Modified: Added Interface VLAN mode.Parameters 0-255 Specify the maximum response time interval in tenths of a second.Range: 0 to 255 tenths of a secondVersion 2.3 Modified: Changed from ip igmp query-max-response-time to ip igmpquery-max-resp-time and added Interface VLAN mode.Version 2.3 Modified: Added Interface VLAN mode.
