LAG/Port Channel Commands | 293Example Figure 18-108. show interfaces description Command ExampleRelatedCommandsdot1p-priorityThis command configures the priority for untagged frames.Syntax dot1p-priority 0–7The 0–7 field is an integer that sets the priority value for untagged frames received.Mode Interface Port Channel ConfigCommandHistoryS50 #confS50 (Config)#interface 1/0/1S50 (Interface 1/0/1)#description "1/0/1 is access port"S50 (Interface 1/0/1)#exitS50 (Config)#interface 1/0/30S50 (Interface 1/0/30)#description 'management port in vlan 30'S50 (Interface 1/0/30)#exitS50 (Config)#exitS50 #show interfaces description 1/0/1Interface.......1/0/1IfIndex.........1Description.....1/0/1 is access portMAC Address.....00:01:E8:D5:BA:C0Bit Offset Val..1S50 #show interfaces description 1/0/30Interface.......1/0/30IfIndex.........30Description.....management port in vlan 30MAC Address.....00:01:E8:D5:BA:C0Bit Offset Val..30S50 #interface vlan Creates a VLAN, assigns it an ID and then enters the Interface VLAN modeshow interfaces Displays information, including the description, about a selected interface.show running-config Display/capture the current setting of different protocol packages supported on theswitch.Version 2.5.1 Introduced in the new Interface Port Channel Config mode.RelatedCommands channel-member Add a port or range of ports to the selected LAG. LAG ports must be physical ports,not other LAGs.interfaceport-channelCreates the port channel (LAG) or, if the port channel is already created, invokes theInterface Port Channel Config mode.show interfacesport-channelDisplays an overview of all port channels (LAGs) on the switch or details on theselected LAG.
