218 | Stacking Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m CommandHistoryRelatedCommandsarchive download-swThis command downloads the SFTOS software image (.OPR file) to the switch. The url is the transfermode. The switch must be reset for the new code to start running.Syntax archive download-sw urlMode Stacking Config (prompt is “(config-stack)#”)CommandHistoryRelatedCommandsmember This command is optional. The command is executed on the management unit to pre-configure thestacking characteristics of a switch that will join the stack.Syntax member unit switchindexThe unit is the stack ID (from 1 to 8) to which you want to assign the switch that you areadding to the stack. The ID must be a currently unused number.The switchindex is the SID number of the supported switch type that is displayed by showsupported switchindex, indicating the type of the switch being preconfigured.Use no member unit to remove the specified switch from the stack.Mode Stacking Config (prompt is “(config-stack)#”)RelatedCommandsVersion 2.5.1 Deprecatedcopy Copy software from the stack management unit to a stack member.copy {image1 | image2} unit://unit/{image1 | image2}Version 2.5.1 Deprecatedcopy Download software to the stack management unit.copy tftp://tftp_server_ip_address/path/filename {image1 | image2}Note: The required switch index (SID) can be obtained by executing the show supportedswitchtype command in User Exec or Privileged Exec mode.show supported switchtype Displays the switch index (SID) of supported switchesstack Accesses the Stacking Config mode