LAG/Port Channel Commands | 299port-channel nameThis command defines a name for the port channel (LAG).Mode Global ConfigCommandHistoryport-channel staticcapabilityThis command enables the support of port channels (static link aggregations - LAGs) on the device. Bydefault, the static capability for all port channels is disabled.CommandHistoryport lacpmode enableThis command enables Link Aggregation Control Protocol (LACP) on a port.The no version of this command disables LACP on a port.Syntax [no] port lacpmode enableDefault disabledMode Interface Config; Interface Range, which is indicated by the (conf-if-range-interface)# prompt, such as(conf-if-range-vlan 10-20)#.CommandHistoryport lacpmode enable allThis command enables Link Aggregation Control Protocol (LACP) on all ports.The no version of this command disables Link Aggregation Control Protocol (LACP) on all ports.Syntax [no] port lacpmode enable allMode Global ConfigVersion 2.5.1 Deprecated: Replaced by description (port channel), which adds a text description of theport channel from the new Interface Port Channel Config mode.Version 2.5.1 Replaced by protocol static, in the new Interface Port Channel Config mode.Version 2.5 Deprecated. Use protocol lacp and protocol static.Version 2.3 Added Interface VLAN and Interface Range modes.RelatedCommandsinterface range Defines an interface range and accesses the Interface Range modeprotocol lacp Reenables LACP on a LAG.protocol static Converts a LAG from LACP to static.
