440 | OSPF Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Type-value—External Type 1 or External Type 2 routesTag-value—Decimal value attached to each external routeSubnets—For redistributing routes into OSPF, the scope of redistribution for the specified protocolDistribute-list—The access list used to filter redistributed routesDefault-info originate—Indicates whether the default routes received from other source protocols areadvertised or notMax Paths—Maximum number of paths that OSPF can report for a given destinationshow ip ospf abrThis command displays the internal OSPF routing table entries to Area Border Routers (ABR).Syntax show ip ospf abrMode Privileged Exec and User ExecReport Fields Type—The type of the route to the destination. It can be either:• intra — Intra-area route• inter — Inter-area routeRouter ID—Router ID of the destinationCost—Cost of using this routeArea ID—The area ID of the area from which this route is learnedNext Hop—Next hop toward the destinationNext Hop Intf—The outgoing router interface to use when forwarding traffic to the next hopshow ip ospf areaThis command displays information about the area. The areaid identifies the OSPF area that is beingdisplayed.Syntax show ip ospf area areaidMode Privileged Exec and User ExecReport Fields AreaID—The area ID of the requested OSPF areaAging Interval—A number representing the aging interval for this areaExternal Routing—A number representing the external routing capabilities for this areaAuthentication Type—The configured authentication type to use for this area