Time Commands | 247ParametersUse the no sntp server remove ipaddress command to delete the server from the list of SNTPservers.Mode Global Configshow sntp This command is used to display SNTP settings and status.Syntax show sntpMode Privileged ExecExample Figure 14-86. show sntp Command ExampleFieldDescriptionsLast Update Time—Time of last clock updateLast Attempt Time—Time of last transmit query (in unicast mode).Last Attempt Status—Status of the last SNTP request (in unicast mode) or unsolicited message (inbroadcast mode).Broadcast Count—Current number of unsolicited broadcast messages that have been received andprocessed by the SNTP client since last reboot.Multicast Count—Current number of unsolicited multicast messages that have been received andprocessed by the SNTP client since last rebootipaddress Specify either the IPv4 address of the server or a DNS hostname. If DNS, then thathostname should be resolved into an IP address each time a SNTP request is sent to it.priority Optionally, specify the priority of this server entry in determining the sequence of serversto which SNTP requests will be sent. The client continues sending requests to differentservers until a successful response is received or all servers are exhausted. A server entrywith a priority of 1 is queried before a server with a priority of 2, and then a server with apriority of 3. If more than one server has the same priority then the requesting order followsthe lexicographical ordering of the entries in this table. Allowed range is 1 to 3. Defaultvalue is 1.version If priority is specified, optionally identify the NTP version running on the server. Allowedrange is (1 to 4). Default value is 4.portid The port ID is a value from 1–65535.Force10# show sntpLast Update Time: AUG 20 09:04:15 2006Last Unicast Attempt Time: AUG 20 09:04:15 2006Last Attempt Status: SuccessBroadcast Count: 0Force10#