Dell Force10 S2410-01-10GE-24P Command Reference Manual

Also see for Force10 MXL Blade: Configuration guide Getting started guide Manual Deployment guide Configuration

Contents

32 | Using the Command Line Interfacew w w . d e l l . c o m | s u p p o r t . d e l l . c o m The commands available to the operator at any point in time depend upon the mode. Entering aquestion mark (?) at the CLI prompt displays a list of the available commands, along with descriptionsof the commands.The CLI provides the following modes:User Exec Mode. When the operator logs into the CLI, the User Exec mode is the initial mode.The User Exec mode contains a limited set of commands.Command Prompt: hostname >Privileged Exec Mode. To have access to the full suite of commands, you must enter thePrivileged Exec mode. The Privileged Exec mode requires password authentication. In Privileged Execmode, you can issue any User Exec mode command or enter the Global Config mode. CommandPrompt: hostname #Global Config Mode. This mode permits you to make general modifications to the runningconfiguration. From the Global Configuration mode, you can enter all of the configuration-specificmodes listed below. Command Prompt: hostname (Config)#From the Global Config mode, you may enter the following configuration modes:Interface Port Channel Config Mode. This mode, introduced in SFTOS Version 2.5.1,groups commands pertaining to port channels.Interface Config Mode. Many features are enabled for a particular interface. The Interfacecommands enable or modify the operation of an interface.In this mode, a physical port is set up for a specific logical connection operation. The Interface Configmode provides access to the router interface configuration commands. Command Prompt: hostname(Interface <unit/slot/port>)#The resulting prompt sequence for the interface configuration command entered in the GlobalConfiguration mode is shown here:hostname (Config)# interface 1/0/1hostname (Interface 1/0/1)#DHCP Pool Config Mode. Use the ip dhcp pool pool-name command to access the DHCPPool Config. The mode is used for configuring the switch as a DHCP server.Line Config Mode. Use this mode to configure the console interface. You may configure theinterface from the directly connected console or the virtual terminal used with Telnet. CommandPrompt: hostname (Line)#Policy Map Mode. Use the policy-map command to access the QoS policymap configuration mode to configure the QoS policy map. The prompt sequence is:hostname (Config)# policy map hostname (Config-policy-map)#Policy Class Mode. Use the class command to access the QoS policy-classmapmode to attach/remove a diffserv class to a policy and to configure the QoS policy class. The promptsequence is:hostname (Config policy-map)# class Note: The hostname here is a placeholder for the prompt that you create using thehostname command. See hostname on page 37.