142 | VLAN Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o m Default enabledMode Interface VLANCommandHistoryRelatedCommandsvlan association subnetThis command configures an IP subnet-based VLAN by associating the VLAN with an IP address andsubnet mask.The no version of this command removes the association of the VLAN with the specified IP addressand subnet mask.Syntax [no] vlan association subnet ipaddr netmaskFor ipaddr and netmask, enter the IP address and subnet mask, used as the basis for the VLAN.Default enabledMode Interface VLANCommandHistoryVersion 2.5.2 Unsupported: not tested in 2.5.2Version 2.5.1 Introducedinterface vlan Creates a new VLAN, or selects one based on ID, and then enters the InterfaceVLAN mode, which provides access to VLAN configuration commands for thespecified VLAN.show mac-addr-table Displays forwarding database entries, including MAC addresses by VLAN.show port Displays port information for a selected port or for all portsshow interfaces Displays information about a selected interface or VLAN.show vlan Displays information about VLANs, either detailed information for a specificVLAN or summary information for all configured VLANs.show vlan associationmacDisplays information about either all MAC-based VLANs or the VLAN associatedwith a specific MAC address.show vlan associationsubnetDisplays information about either all IP subnet-based VLANs or the VLANassociated with a specific IP address and mask.Note: The S50V and S25P support IP subnet-based VLANs. The original S50 doesnot.Version 2.5.2 Unsupported: not tested in 2.5.2Version 2.5.1 Introduced