GARP Commands | 25115GARP CommandsThis chapter provides a detailed explanation of the General Attribute Registration Protocol (GARP)commands, including GVRP and GMRP commands. The commands are divided into two functionalgroups:• Show commands display switch settings, statistics, and other information.• Configuration commands configure features and options of the switch. For every configurationcommand, there is a show command that displays the configuration setting.The sections in this chapter are:• GARP Commands on page 251• GARP VLAN Registration Protocol (GVRP) Commands on page 254• GARP Multicast Registration Protocol (GMRP) Commands on page 257GARP CommandsThe commands in this sections are:• set garp timer join on page 251• set garp timer leave on page 252• set garp timer leaveall on page 253• show garp on page 253set garp timer joinThis command sets the GVRP join time per port and per GARP. Join time is the interval between thetransmission of GARP Protocol Data Units (PDUs) registering (or re-registering) membership for aVLAN or multicast group.This command has an effect only when GVRP is enabled. The time is from 10 to 100 (centiseconds).the value 20 centiseconds is 0.2 seconds.Syntax nECu: sduCa,EsuTeaou10-100oeunECu: sduCa,EsuTeaouNote: The GARP and GVRP features were available in SFTOS before version 2.5.1, but thecommands were not tested in either 2.5.1 or 2.5.2, so the commands in this chapter are notsupported.
