IGMP Snooping Commands | 279RelatedCommandsset igmp fast-leaveCommandHistoryRelatedCommandsset igmp groupmembership-interval (system level)This command sets the IGMP Group Membership Interval time on the system. The Group MembershipInterval time is the amount of time in seconds that a switch will wait for a report from a particulargroup on a particular interface before deleting the interface from the entry. This value must be greaterthan the IGMP Maximum Response time value.Syntax [no] set igmp groupmembership-interval 2-3600The range is 2 to 3600 seconds.The no version of this command sets the IGMP Group Membership Interval time on the system to 260seconds.Default 260Mode Global ConfigRelatedCommandsset igmp groupmembership-interval (interface level)CommandHistoryRelatedCommandsigmp enable (global) Enables IGMP Snooping on the system.igmp enable(interface)Enables IGMP Snooping on a selected interface.Version 2.3 Revised to igmp fast-leave.igmp fast-leave Enables or disables IGMP Snooping fast-leave admin mode on a selected interface.igmp enable (global) Enables IGMP Snooping on the system.igmp enable (global) Enables IGMP Snooping on the system.show igmpsnooping Displays IGMP Snooping status information.Version 2.3 Revised to igmp groupmembership-interval (interface level).igmp groupmembership-interval Sets the IGMP Group Membership Interval time on a particularinterface.igmp enable (interface) Enables IGMP Snooping on a selected interface.
