430 | OSPF Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mdefault-information originate (OSPF)This command is used to control the advertisement of default routes.Syntax default-information originate [always] [metri O0-16777215] [metric-type {1 | 2}]The no default-information originate [metric] [metric-type] command sets the advertisement ofroutes to the default.Default metric—unspecified; type—2Mode Router OSPF Configdefault-metric (OSPF)This command is used to set a default for the metric of distributed routes.Syntax default-metric 1-16777215The no default-metric command sets a default for the metric of distributed routes.Mode Router OSPF Configdistance ospfThis command sets the route preference value of OSPF in the router. Lower route preference values arepreferred when determining the best route.Syntax distance ospf {intra | inter | type1 | type2} 0-255The type of OSPF can be intra, inter, type1, or type2. The OSPF specification (RFC 2328)requires that preferences must be given to the routes learned via OSPF in the following order:intra < inter < type1 < type2.The route preference range is 0 to 255.The no distance ospf {intra | inter | type1 | type2} command sets the default route preferencevalue of OSPF in the router.Default intra = 8; inter = 10; type1 = 13; type2 = 150Mode Router OSPF Configdistribute-list outThis command is used to specify the access list to filter routes received from the source protocol.Syntax [no] distribute-list 1-199 out {rip | static | connected}
