96 | System Configuration Commandsw w w . d e l l . c o m | s u p p o r t . d e l l . c o mTo remove the destination port, use no monitor session 1 destination interface.To remove a source port, use no monitor session 1 source interface unit/slot/port.In other words, removing the source interface requires specifying the port to be removed, but removingthe destination port does not require specifying the destination port, since there can be only onedestination port.Default NoneMode Global ConfigUsageInformationIn an S-Series stack, destination and source ports can be on separate stack members. A stack has a limitof one port mirroring session and one destination port. Remove an existing source or destination portbefore replacing it with another. For more on configuring port monitoring (port mirroring), see the PortMirroring chapter of the SFTOS Configuration Guide.monitor session 1 modeThis command sets the monitor session (port monitoring) mode to enabled. The probe and monitoredports must be configured before port monitoring can be enabled. When enabled, the probe portmonitors all traffic received and transmitted on the physical monitored port. It is not necessary todisable port monitoring before modifying the probe and monitored ports.A session is operationally active if and only if both a destination port and at least one source port isconfigured. If neither is true, the session is inactive.A port configured as a destination port acts as a mirroring port when the session is operationally active.If it is not, the port acts as a normal port and participates in all normal operation with respect totransmitting traffic.Syntax [no] monitor session 1 modeThe no version of this command sets the monitor session (port monitoring) mode to disabled.Default disabledMode Global ConfigParameters destination interfaceunit/slot/portSpecify the probe port (target port). The probe port cannot be a VLANmember.source interface unit/slot/portSpecify the source interface (mirrored port). The port can be a part of anyVLAN.mode Enable/disable the port mirroring session. See monitor session 1 mode onpage 96.RelatedCommandsmonitor session 1 mode Sets the monitor session (port monitoring) mode to enabled.mtu (port) Removes the destination port and all source ports from the mirroringconfiguration.show monitor session Shows the mirroring configuration.