VXLAN-INSTANCE modelocal-vtep-ip IP Address4 Create a VNI profile to associate with remote VTEP configuration.VXLAN-INSTANCE modevni—profile profile name5 Associate VNID to the VNI profile.VNI-PROFILE modevnid VNID Range6 Create a remote tunnel and associate the remote VTEP to the VNID.VXLAN-INSTANCE moderemote—vtep—ip remote IP Address vni-profile profile name7 Enable the VXLAN.VXLAN-INSTANCE modeno shutdown8 Enable VXLAN instance on the interface. The interface should not be on layer 2.INTERFACE modevxlan-instance Instance ID9 Associate VNID to VLAN.INTERFACE VLAN modevxlan-vnid VNIDLimitations on Static VXLANWhile configuring a static VXLAN, the following conditions apply:• Static VXLAN is not supported in Stacking and VLT environments.• Routing over VXLAN is not supported.• SNMP and REST API are not supported for VXLAN configurations.• Multicast over VXLAN is not supported.• Only 4K VNIs are supported while configuring static VXLAN.• In multicast and broadcast traffic, even though the remote VTEP is reachable through the ECMP path, load balancing is not supported.• The 802.1p QOS markings are not preserved in the tags that go through the VXLAN tunnel.• Single VNI can be mapped to Single VLAN only.• Only one Remote VTEP can be reached through a single interface in a broadcast domain.Displaying Static VXLAN ConfigurationsTo display the static VXLAN configurations, use the following commands.Examples of the show vxlan-instance CommandThe following example displays the basic configuration details.Dell# show vxlan vxlan-instance 1Instance : 1Mode : StaticVirtual Extensible LAN (VXLAN) 1063