Configure the System to be a DHCP ClientA DHCP client is a network device that requests an IP address and configuration parameters from a DHCP server.Implement the DHCP client functionality as follows:• The switch can obtain a dynamically assigned IP address from a DHCP server. A start-up configuration is not received. Use bare metalprovisioning (BMP) to receive configuration parameters (Dell Networking OS version and a configuration file). BMP is enabled as afactory-default setting on a switch.A switch cannot operate with BMP and as a DHCP client simultaneously. To disable BMP in EXEC mode, use the stop bmp command.After BMP stops, the switch acts as a DHCP client.• Acquire a dynamic IP address from a DHCP client is for a limited period or until the client releases the address.• A DHCP server manages and assigns IP addresses to clients from an address pool stored on the server. For more information, refer toConfiguring the Server for Automatic Address Allocation.• Dynamically assigned IP addresses are supported on Ethernet, VLAN, and port-channel interfaces.• The public out-of-band management interface and default VLAN 1 are configured by default as a DHCP client to acquire a dynamic IPaddress from a DHCP server.• By default, the switch is configured to operate in BMP mode as a DHCP client that sends DHCP requests to a DHCP server to retrieveconfiguration information (IP address, boot-image filename, and configuration file). All ports and management interfaces are brought upin Layer 3 mode and pre-configured with no shutdown and no ip address. For this reason, you cannot enter configurationcommands to set up the switch. To interrupt a BMP process, prevent a loop from occurring, and apply the Dell Networking OS imageand startup configuration stored in the local flash, enter the stop bmp command from the console. To reconfigure the switch so thatit boots up in normal mode using the Dell Networking OS image and startup configuration file in local flash, enter the reload-typenormal-reload command and save it to the startup configuration:Dell# reload-type normal-reloadDell# write memoryDell# reload• To re-enable BMP mode for the next reload, enter the reload-type jump-start command.• If the management port is associated with any non-default VRF, then the ip address dhcp command does not work.Configuring the DHCP Client SystemThis section describes how to configure and view an interface as a DHCP client to receive an IP address.Dell Networking OS Behavior: The ip address dhcp command enables DHCP server-assigned dynamic addresses on an interface.The setting persists after a switch reboot. To stop DHCP transactions and save the dynamically acquired IP address, use the shutdowncommand on the interface. To display the dynamic IP address and show DHCP as the mode of IP address assignment, use the showinterface type slot/port[/subport] command. To unconfigure the IP address, use the no shutdown command when thelease timer for the dynamic IP address is expired. The interface acquires a new dynamic IP address from the DHCP server.To configure a secondary (backup) IP address on an interface, use the ip address command at the INTERFACE configuration level.Use the no ip address dhcp command to:• Release the IP address dynamically acquired from a DHCP server from the interface.• Disable the DHCP client on the interface so it cannot acquire a dynamic IP address from a DHCP server.• Stop DHCP packet transactions on the interface.When you enter the release dhcp command, the IP address dynamically acquired from a DHCP server is released from an interface.The ability to acquire a new DHCP server-assigned address remains in the running configuration for the interface. To acquire a new IPaddress, use the renew DHCP command in EXEC Privilege mode or the ip address dhcp command in INTERFACE Configurationmode.302 Dynamic Host Configuration Protocol (DHCP)
