When the feature is enabled using the management egress-interface-selection command, the following events are performed:• The CLI prompt changes to the EIS mode.• In this mode, you can run the application and no application commands• Applications can be configured or unconfigured as management applications using the application or no applicationcommand. All configured applications are considered as management applications and the rest of them as non-managementapplications.• All the management routes (connected, static and default) are duplicated and added to the management EIS routing table.• Any new management route added is installed to both the EIS routing table and default routing table.• For management applications, route lookup is preferentially done in the management EIS routing table for all traffic. management port isthe preferred egress port. For example, if SSH is a management application, an SSH session to a front-panel port IP on the peer box isinitiated via management port only, if the management port is UP and management route is available.• If SSH request is received on the management port destined to the management port IP address, the response to the request is sentout of the management port by performing a route lookup in the EIS routing table• If the SSH request is received on the front-end port destined for the front-end IP address, the response traffic is sent by doing a routelookup in the default routing table only.• If the management port is down or route lookup fails in the management EIS routing table, packets are dropped.• For all non-management applications, traffic exits out of either front-end data port or management port based on route lookup indefault routing table.• Ping and traceroute are always non-management applications and route lookup for these applications is done in the default routing tableonly.• For ping and traceroute utilities that are initiated from the switch, if reachability needs to be tested through routes in the managementEIS routing table, you must configure ICMP as a management application.• If ping and traceroute are destined to the management port IP address, the response traffic for these packets is sent by doing routelookup in the EIS routing table.When the feature is disabled using the no management egress-interface-selection command, the following operations areperformed:• All management application configuration is removed.• All routes installed in the management EIS routing table are removed.Handling of Management Route ConfigurationWhen the EIS feature is enabled, the following processing occurs:• All existing management routes (connected, static and default) are duplicated and added to the management EIS routing table.• Any management static route newly added using the management route CLI is installed to both the management EIS routing tableand default routing table.• As per existing behavior, for routes in the default routing table, conflicting front-end port routes if configured has higher precedenceover management routes. So there can be scenarios where the same management route is present in the EIS routing table but not inthe default routing table.• Routes in the EIS routing table are displayed using the show ip management-eis-route command.• In the netstat output, the prefix “mgmt” is added to routes in the EIS table so that the user can distinguish between routes in the EISRouting table and default routing table.• If the management port IP address is removed, the corresponding connected route is removed from both the EIS routing table anddefault routing table.• If a management route is deleted, then the route is removed from both the EIS routing table and default routing table.Internet Group Management Protocol (IGMP) 385