The following example shows the SNMP trap that is sent when connectivity to the syslog server is lost:DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (19738) 0:03:17.38 SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::enterprises.6027.3.30.1.1.1 SNMPv2-SMI::enterprises.6027.3.30.1.1 = STRING:"NOT_REACHABLE: Syslog server10.11.226.121 (port: 9140) is not reachable" SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 =INTEGER: 2Following is the sample audit log message that other syslog servers that are reachable receive:Oct 21 00:46:13: dv-fedgov-s4810-6: %EVL-6-NOT_REACHABLE:Syslog server 10.11.226.121 (port:9140) is not reachableFollowing example shows the SNMP trap that is sent when connectivity to the syslog server is resumed:DISMAN-EVENT-MIB::sysUpTimeInstance = Timeticks: (10230) 0:01:42.30 SNMPv2-MIB::snmpTrapOID.0 = OID: SNMPv2-SMI::enterprises.6027.3.30.1.1.2 SNMPv2-SMI::enterprises.6027.3.30.1.1 = STRING:"REACHABLE: Syslog server10.11.226.121 (port: 9140) is reachable"SNMPv2-SMI::enterprises.6027.3.6.1.1.2.0 = INTEGER: 2Following is the sample audit log message that other syslog servers that are reachable receive:Oct 21 05:26:04: dv-fedgov-s4810-6: %EVL-6-REACHABLE:Syslog server 10.11.226.121 (port: 9140)is reachableCopy Configuration Files Using SNMPTo do the following, use SNMP from a remote client.• copy the running-config file to the startup-config file• copy configuration files from the Dell Networking system to a server• copy configuration files from a server to the Dell Networking systemYou can perform all of these tasks using IPv4 or IPv6 addresses. The examples in this section use IPv4 addresses; however, you cansubstitute IPv6 addresses for the IPv4 addresses in all of the examples.The following table lists the relevant MIBs for these functions are.Table 91. MIB Objects for Copying Configuration Files via SNMPMIB Object OID Object Values DescriptioncopySrcFileType .1.3.6.1.4.1.6027.3.5.1.1.1.1.2 1 = Dell Networking OS file2 = running-config3 = startup-configSpecifies the type of file to copyfrom. The range is:• If copySrcFileType is running-config or startup-config, thedefault copySrcFileLocationis flash.• If copySrcFileType is a binaryfile, you must also specifycopySrcFileLocation andcopySrcFileName.copySrcFileLocation .1.3.6.1.4.1.6027.3.5.1.1.1.1.3 1 = flash2 = slot03 = tftp4 = ftp5 = scpSpecifies the location of sourcefile.• If copySrcFileLocation is FTPor SCP, you must specifycopyServerAddress,copyUserName, andcopyUserPassword.870 Simple Network Management Protocol (SNMP)