Fast Convergence (OSPFv2, IPv4 Only)Fast convergence allows you to define the speeds at which LSAs are originated and accepted, and reduce OSPFv2 end-to-endconvergence time.Dell Networking OS allows you to accept and originate LSAs as soon as they are available to speed up route information propagation.NOTE: The faster the convergence, the more frequent the route calculations and updates. This impacts CPU utilization and mayimpact adjacency stability in larger topologies.Multi-Process OSPFv2 with VRFMulti-process OSPF with VRF is supported on the Dell Networking OS. Only one OSPFv2 process per VRF is supported.Multi-process OSPF allows multiple OSPFv2 processes on a single router. Multiple OSPFv2 processes allow for isolating routing domains,supporting multiple route policies and priorities in different domains, and creating smaller domains for easier management.Each OSPFv2process has a unique process ID and must have an associated router ID. There must be an equal number of interfaces and must be inLayer-3 mode for the number of processes created. For example, if you create five OSPFv2 processes on a system, there must be at leastfive interfaces assigned in Layer 3 mode. Each OSPFv2 process is independent. If one process loses adjacency, the other processescontinue to function.Processing SNMP and Sending SNMP TrapsOnly the process in default vrf can process the SNMP requests and send SNMP traps.NOTE: SNMP gets request corresponding to the OspfNbrOption field in the OspfNbrTable returns a value of66.OSPF ACK PackingThe OSPF ACK packing feature bundles multiple LS acknowledgements in a single packet, significantly reducing the number of ACKpackets transmitted when the number of LSAs increases.This feature also enhances network utilization and reduces the number of small ACK packets sent to a neighboring router. OSPF ACKpacking is enabled by default and non-configurable.Setting OSPF Adjacency with Cisco RoutersTo establish an OSPF adjacency between Dell Networking and Cisco routers, the hello interval and dead interval must be the same on bothrouters.In Dell Networking OS, the OSPF dead interval value is, by default, set to 40 seconds, and is independent of the OSPF hello interval.Configuring a hello interval does not change the dead interval in Dell Networking OS. In contrast, the OSPF dead interval on a Cisco routeris, by default, four times as long as the hello interval. Changing the hello interval on the Cisco router automatically changes the deadinterval.To ensure equal intervals between the routers, use the following command.• Manually set the dead interval of the Dell Networking router to match the Cisco configuration.INTERFACE modeip ospf dead-interval 628 Open Shortest Path First (OSPFv2 and OSPFv3)