ETS Operation with DCBxThe following section describes DCBx negotiation with peer ETS devices.In DCBx negotiation with peer ETS devices, ETS configuration is handled as follows:• ETS TLVs are supported in DCBx versions CIN, CEE, and IEEE2.5.• The DCBx port-role configurations determine the ETS operational parameters (refer to Configure a DCBx Operation).• ETS configurations received from TLVs from a peer are validated.• If there is a hardware limitation or TLV error:• DCBx operation on an ETS port goes down.• New ETS configurations are ignored and existing ETS configurations are reset to the default ETS settings.• ETS operates with legacy DCBx versions as follows:• In the CEE version, the priority group/traffic class group (TCG) ID 15 represents a non-ETS priority group. Any priority groupconfigured with a scheduler type is treated as a strict-priority group and is given the priority-group (TCG) ID 15.• The CIN version supports two types of strict-priority scheduling:• Group strict priority: Use this to increase its bandwidth usage to the bandwidth total of the priority group and allow a singlepriority flow in a priority group. A single flow in a group can use all the bandwidth allocated to the group.• Link strict priority: Use this to increase to the maximum link bandwidth and allow a flow in any priority group.NOTE: CIN supports only the dot1p priority-queue assignment in a priority group. To configure a dot1p priority flowin a priority group to operate with link strict priority, you configure: The dot1p priority for strict-priority scheduling(strict-priority command). The priority group for strict-priority scheduling (scheduler strictcommand.Configuring Bandwidth Allocation for DCBx CINAfter you apply an ETS output policy to an interface, if the DCBx version used in your data center network is CIN, you may need toconfigure a QoS output policy to overwrite the default CIN bandwidth allocation.This default setting divides the bandwidth allocated to each port queue equally between the dot1p priority traffic assigned to the queue.To create a QoS output policy that allocates different amounts of bandwidth to the different traffic types/ dot1p priorities assigned to aqueue and apply the output policy to the interface, follow these steps.1 Create a QoS output policy.CONFIGURATION modeDell(conf)#qos-policy-output test12The maximum 32 alphanumeric characters.2 Configure the percentage of bandwidth to allocate to the dot1p priority/queue traffic in the associated L2 class map.QoS OUTPUT POLICY modeDell(conf-qos-policy-out)#bandwidth-percentage 100The default is none.3 Repeat Step 2 to configure bandwidth percentages for other priority queues on the port.QoS OUTPUT POLICY modeDell(conf-qos-policy-out)#bandwidth-percentage 1004 Exit QoS Output Policy Configuration mode.QoS OUTPUT POLICY mode268 Data Center Bridging (DCB)