Storm ControlStorm control allows you to control unknown-unicast, muticast, and broadcast traffic on Layer 2 and Layer 3 physical interfaces.Dell Networking Operating System (OS) Behavior: Dell Networking OS supports unknown-unicast, muticast, and broadcast control forLayer 2 and Layer 3 traffic.Dell Networking OS Behavior: The minimum number of packets per second (PPS) that storm control can limit on the device is two.To view the storm control broadcast configuration show storm-control broadcast | multicast | unknown-unicast |pfc-llfc[interface] command.EXEC PrivilegeTo view the storm control multicast configuration, use the show storm-control broadcast | multicast | unknown-unicast | pfc-llfc [interface] command.EXEC PrivilegeExample:Dell#show storm-control multicast Tengigabitethernet 1/1Multicast storm control configurationInterface Direction Packets/Second-----------------------------------------Te 1/1 Ingress 5Dell#To display the storm control unknown-unicast configuration, use the show storm-control unknown-unicast [interface]command.EXEC PrivilegeConfigure Storm ControlStorm control is supported in INTERFACE mode and CONFIGURATION mode.Configuring Storm Control from INTERFACE ModeTo configure storm control, use the following command.From INTERFACE mode:• You can only configure storm control for ingress traffic.• If you configure storm control from both INTERFACE and CONFIGURATION mode, the INTERFACE mode configurations override theCONFIGURATION mode configurations.• The storm control is calculated in packets per second.53920 Storm Control
