2 Member not present3 Standby online S4810 S4810 8-3-7-13 64The following example shows removing a stack member (after).Dell#show system briefStack MAC : 00:01:e8:8a:df:e6Reload Type : normal-reload-- Stack Info --Unit UnitType Status ReqTyp CurTyp Version Ports-------------------------------------------------------0 Management online S4810 S4810 8-3-7-13 641 Member not present S48102 Member not present3 Standby online S4810 S4810 8-3-7-13 644 Member not present5 Member not present6 Member not present7 Member not present8 Member not present9 Member not present10 Member not present11 Member not presentRemoving Front End Port StackingTo remove the configuration on the front end ports used for stacking, use the following commands.1 Remove the stack group configuration that is configured.CONFIGURATION modeno stack-unit id stack-group id2 Save the stacking configuration on the ports.EXEC Privilege modewrite memory3 Reload the switch.EXEC Privilege modereloadAfter the units are reloaded, the system reboots. The units come up as standalone units after the reboot completes.Troubleshoot a StackTo troubleshoot a stack, use the following recovery tasks.• Recover from Stack Link Flaps• Recover from a Card Problem State on a StackStacking 917
