ETS parameters ETS Configuration TLV and ETS Recommendation TLV.Data Center Bridging in a Traffic FlowThe following figure shows how DCB handles a traffic flow on an interface.Figure 29. DCB PFC and ETS Traffic HandlingEnabling Data Center BridgingDCB is automatically configured when you configure FCoE or iSCSI optimization.Data center bridging supports converged enhanced Ethernet (CEE) in a data center network. DCB is disabled by default. It must beenabled to support CEE.• Priority-based flow control• Enhanced transmission selection• Data center bridging exchange protocol• FCoE initialization protocol (FIP) snoopingDCB processes virtual local area network (VLAN)-tagged packets and dot1p priority values. Untagged packets are treated with a dot1ppriority of 0.For DCB to operate effectively, you can classify ingress traffic according to its dot1p priority so that it maps to different data queues. Thedot1p-queue assignments used are shown in the following table.To enable DCB, enable either the iSCSI optimization configuration or the FCoE configuration.To enable DCB with PFC buffers on a switch, enter the following commands, save the configuration, and reboot the system to allow thechanges to take effect.1 Enable DCB.CONFIGURATION mode256 Data Center Bridging (DCB)