192.161.1.0/24 auto-summary192.162.3.0/24[120/1] via 29.10.10.12, 00:01:22, Fa 1/49192.162.3.0/24 auto-summaryTo disable RIP globally, use the no router rip command in CONFIGURATION mode.Configure RIP on InterfacesWhen you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP routes.By default, interfaces that you enable and configure with an IP address in the same subnet as the RIP network address receive RIPv1 andRIPv2 routes and send RIPv1 routes.Assign IP addresses to interfaces that are part of the same subnet as the RIP network identified in the network command syntax.Controlling RIP Routing UpdatesBy default, RIP broadcasts routing information out all enabled interfaces, but you can configure RIP to send or to block RIP routinginformation, either from a specific IP address or a specific interface.To control which devices or interfaces receive routing updates, configure a direct update to one router and configure interfaces to blockRIP updates from other sources.To control the source of RIP route information, use the following commands.• Define a specific router to exchange RIP information between it and the Dell Networking system.ROUTER RIP modeneighbor ip-addressYou can use this command multiple times to exchange RIP information with as many RIP networks as you want.• Disable a specific interface from sending or receiving RIP routing information.ROUTER RIP modepassive-interface interfaceAssigning a Prefix List to RIP RoutesAnother method of controlling RIP (or any routing protocol) routing information is to filter the information through a prefix list. A prefix list isapplied to incoming or outgoing routes.Those routes must meet the conditions of the prefix list; if not, Dell Networking OS drops the route. Prefix lists are globally applied on allinterfaces running RIP. Configure the prefix list in PREFIX LIST mode prior to assigning it to the RIP process.For configuration information about prefix lists, refer to Access Control Lists (ACLs).To apply prefix lists to incoming or outgoing RIP routes, use the following commands.• Assign a configured prefix list to all incoming RIP routes.ROUTER RIP modedistribute-list prefix-list-name in• Assign a configured prefix list to all outgoing RIP routes.ROUTER RIP modedistribute-list prefix-list-name outTo view the current RIP configuration, use the show running-config command in EXEC mode or the show config command inROUTER RIP mode.768 Routing Information Protocol (RIP)
