To reset the number of FP blocks to the default, use the no version of these commands. By default, zero groups are allocated for the ACLin VCAP. ACL VLAN groups or CAM optimization is not enabled by default. You must also allocate the slices for CAM optimization.To display the number of FP blocks that is allocated for the different VLAN services, use the show cam-acl-vlan command. After youconfigure the ACL VLAN groups, reboot the system to store the settings in nonvolatile storage. During CAM initialization, the chassismanager reads the NVRAM and allocates the dynamic VCAP regions.Unified Forwarding Table (UFT) ModesUnified Forwarding Table (UFT) consolidates the resources of several search tables (Layer 2, Layer 3 Hosts, and Layer 3 Route [LongestPrefix Match — LPM]) into a single flexible resource. Dell Networking OS supports several UFT modes to extract the forwarding tables, asrequired. By default, Dell Networking OS initializes the table sizes to UFT mode 2 profile, since it provides a reasonable shared memory forall the tables. The other supported UFT modes are scaled-l3–hosts (UFT mode 3) and scaled-l3–routes (UFT mode 4).Table 7. UFT Modes — Table SizeUFT Mode L2 MAC Table Size L3 Host Table Size L3 LPM Table SizeDefault 160K 144K 16KScaled-l3-hosts 96K 208K 16KScaled-l3-routes 32K 16K 128KConfiguring UFT ModesTo configure the Unified Forwarding Table (UFT) modes, follow these steps.1 Select a mode to initialize the maximum scalability size for L2 MAC table or L3 Host table or L3 Route table.CONFIGURATIONhardware forwarding-table modeDell(conf)#hardware forwarding-table mode ?scaled-l3-hosts Forwarding table mode for scaling L3 host entriesscaled-l3-routes Forwarding table mode for scaling L3 route entriesDell(conf)#Dell(conf)#hardware forwarding-table mode scaled-l3-hostsHardware forwarding-table mode is changed. Save the configuration and reload to take effect.Dell(conf)#endDell#write mem!01:13:36: %STKUNIT0-M:CP %FILEMGR-5-FILESAVED: Copied running-config to startup-config inflash by defaultDell(conf)#Dell(conf)#endDell#01:13:44: %STKUNIT0-M:CP %SYS-5-CONFIG_I: Configured from consoleDell#2 Display the hardware forwarding table mode in the current boot and in the next boot.EXEC Privilegeshow hardware forwarding-table modeDell#show hardware forwarding-table modeCurrent Settings Next Boot SettingsMode : Default scaled-l3-routes108 Access Control List (ACL) VLAN Groups and Content Addressable Memory (CAM)