Auto reboot Stack-unit: DisabledAuto failover limit: 3 times in 60 minutes-- Stack-unit Failover Record --------------------------------------------------Failover Count: 0Last failover timestamp: NoneLast failover Reason: NoneLast failover type: None-- Last Data Block Sync Record: --------------------------------------------------stack-unit Config: succeeded Nov 25 2014 15:29:58Start-up Config: succeeded Nov 25 2014 15:29:58Runtime Event Log: succeeded Nov 25 2014 15:29:58Running Config: succeeded Nov 25 2014 15:29:58ACL Mgr: succeeded Nov 25 2014 15:29:58LACP: no block sync doneSTP: no block sync doneSPAN: no block sync doneManagement Access on StacksYou can access the stack via the console port or VTY line.• Console access — You may access the stack through the console port of the master unit (stack manager) only. Similar to a standbyRPM, the console port of the standby unit does not provide management capability; only a limited number of commands are available.Member units provide a limited set of commands.• Remote access — You may access the master unit and standby unit in a stack through the dedicated management Ethernet interfaceswith SNMP, SSH, or via Telnet.Example of Accessing Non-Master Units on a Stack via the Console Port-----------------CONSOLE ACCESS ON A STANDBY----------------------------Dell(standby)#?cd Change current directoryclear Reset functionscopy Copy from one file to anotherdelete Delete a filedir List files on a filesystemdisable Turn off privileged commandsenable Turn on privileged commandsexit Exit from the EXECformat Format a filesystemfsck Filesystem check utilitypwd Display current working directoryrename Rename a filereset Reset selected cardshow Show running system informationssh-peer-stack-unit Open a SSH connection to the peer stack-unitstart Start shelltelnet-peer-stack-unit Open a telnet connection to the peer stack-unitterminal Set terminal line parametersupload Upload fileDell(standby)#-----------------CONSOLE ACCESS ON A MEMBER----------------------------Dell(stack-member-1)#?reset-self Reset this unit aloneshow Show running system informationYou can connect two units with two or more stacking cables in case of a stacking port or cable failure. Removal of only one of the cablesdoes not trigger a reset.Stacking 901