-- Fan Status --Unit Bay TrayStatus Fan0 Speed Fan1 Speed--------------------------------------------1 0 up up 7200 up 72001 1 up up 7200 up 7440Speed in RPThe following example shows three switches stacked together in a daisy chain topology.stack-2#show system stack-portsTopology: Daisy chainInterface Connection Link Speed Admin Link Trunk(Gb/s) Status Status Group-------------------------------------------------------3/36 1/36 10 up up3/37 1/37 10 up up3/38 1/38 10 up up3/39 1/39 10 up up3/44 2/36 10 up up3/45 2/37 10 up up3/46 2/38 10 up up3/47 2/39 10 up up1/36 3/36 10 up up1/37 3/37 10 up up1/38 3/38 10 up up1/39 3/39 10 up up2/36 3/44 10 up up2/37 3/45 10 up up2/38 3/46 10 up up2/39 3/47 10 up upstack-2#Remove Units or Front End Ports from a StackTo remove units or front end ports from a stack, use the following instructions.• Removing a Unit from a Stack• Removing Front End Port StackingRemoving a Unit from a StackThe running-configuration and startup-configuration are synchronized on all stack units. A stack member that is disconnected from thestack maintains this configuration.To remove a stack member from the stack, disconnect the stacking cables from the unit. You may do this at any time, whether the unit ispowered or unpowered, online or offline.NOTE: If you remove a unit in the middle of the daisy chain stack, the stack is split into multiple parts and each forms a newstack according to the stacking algorithm described throughout this chapter.Examples of Removing a Stack Member (Before and After)The following example shows removing a stack member (before).Dell#show system briefStack MAC : 00:01:e8:8a:df:e6Reload Type : normal-reload-- Stack Info --Unit UnitType Status ReqTyp CurTyp Version Ports-----------------------------------------------------0 Management online S4810 S4810 8-3-7-13 641 Member online S4810 S4810 8-3-7-13 64916 Stacking