EXEC Privilege modereload conditional nvram-cfg-change• Reload the system into the Dell diagnostics mode.EXEC Privilege modereload dell-diag• Reload the system into the ONIE mode.EXEC Privilege modereload onie [install | uninstall | rescue]Use the install parameter to reload the system and enter the Install mode to install a networking OS.Use the uninstall parameter to reload the system and enter the Uninstall mode to uninstall a networking OS.Use the rescue parameter to reload the system and enter the Rescue mode to access the file system.The following example shows how to reload the system:Dell# reloadProceed with reload [confirm yes/no]: yesThe following example shows how to reload the system into Dell diagnostics mode:Dell#reload dell-diagProceed with reload [confirm yes/no]: yesThe following example shows how to reload the system into ONIE mode:Dell#reload onieProceed with reload [confirm yes/no]: yesThe following example shows how to reload the system into ONIE prompt and enter the install mode directly:Dell#reload onie installProceed with reload [confirm yes/no]: yesRestoring the Factory Default SettingsRestoring the factory-default settings deletes the existing NVRAM settings, startup configuration, and all configured settings such as,stacking or fanout.To restore the factory default settings, use the restore factory-defaults stack-unit {stack—unit—number | all}{clear-all | nvram | bootvar} command in EXEC Privilege mode.CAUTION: There is no undo for this command.Important Points to Remember• When you restore all the units in a stack, these units are placed in standalone mode.• When you restore a single unit in a stack, only that unit is placed in standalone mode. No other units in the stack are affected.• When you restore the units in standalone mode, the units remain in standalone mode after the restoration.• After the restore is complete, the units power cycle immediately.The following example illustrates the restore factory-defaults command to restore the factory default settings.Dell#restore factory-defaults stack-unit 1 nvramManagement 85
