CONFIGURATION modevlt domain domain-idThe range of domain IDs from 1 to 1000.2 Enter an amount of time, in seconds, to delay the restoration of the VLT ports after the system is rebooted.CONFIGURATION modedelay-restore delay-restore-timeThe range is from 1 to 1200.The default is 90 seconds.Reconfiguring the Default VLT Settings (Optional)To reconfigure the default VLT settings, use the following commands.1 Enter VLT-domain configuration mode for a specified VLT domain.CONFIGURATION modevlt domain domain-idThe range of domain IDs is from 1 to 1000.2 After you configure a VLT domain on each peer switch and connect (cable) the two VLT peers on each side of the VLT interconnect,the system elects a primary and secondary VLT peer device. To configure the primary and secondary roles before the election process,use the primary-priority command. Enter a lower value on the primary peer and a higher value on the secondary peer.If the primary peer fails, the secondary peer (with the higher priority) takes the primary role. If the primary peer (with the lowerpriority) later comes back online, it is assigned the secondary role (there is no preemption).3 (Optional) When you create a VLT domain on a switch, Dell Networking OS automatically creates a VLT-system MAC address used forinternal system operations.VLT DOMAIN CONFIGURATION modesystem-mac mac-address mac-addressTo explicitly configure the default MAC address for the domain by entering a new MAC address, use the system-mac command. Theformat is aaaa.bbbb.cccc.Also, reconfigure the same MAC address on the VLT peer switch.Use this command to minimize the time required for the VLT system to synchronize the default MAC address of the VLT domain onboth peer switches when one peer switch reboots.4 (Optional) When you create a VLT domain on a switch, Dell Networking OS automatically assigns a unique unit ID (0 or 1) to each peerswitch.VLT DOMAIN CONFIGURATION modeunit-id {0 | 1}To explicitly configure the default values on each peer switch, use the unit-id command.Configure a different unit ID (0 or 1) on each peer switch.Unit IDs are used for internal system operations.Use this command to minimize the time required for the VLT system to determine the unit ID assigned to each peer switch when onepeer switch reboots.Virtual Link Trunking (VLT) 999
