Ipv6Acl : 0Ipv4Qos : 2L2Qos : 1L2PT : 0IpMacAcl : 0VmanQos : 0VmanDualQos : 0EcfmAcl : 0FcoeAcl : 0iscsiOptAcl : 0ipv4pbr : 0vrfv4Acl : 0Openflow : 0fedgovacl : 0Dell#View CAM UsageView the amount of CAM space available, used, and remaining in each partition (including IPv4Flow and Layer 2 ACL sub- partitions) usingthe show cam-usage command in EXEC Privilege modeThe following output shows CAM blocks usage for Layer 2 and Layer 3 ACLs and other processes that use CAM space:Example of the show cam-usage CommandDell#show cam-usageStackunit|Portpipe| CAM Partition | Total CAM | Used CAM |Available CAM========|========|=================|=============|=============|==============0 0 | IN-L3 ACL | 512 | 1 | 511| | IN-V6 ACL | 0 | 0 | 0| | IN-L2 ACL | 768 | 0 | 768| | OUT-L3 ACL | 158 | 5 | 153| | IN-L3 ECMP GRP| 1024 | 0 | 1024| | OUT-V6 ACL | 158 | 0 | 158| | OUT-L2 ACL | 206 | 7 | 1997 | 0 | IN-L3 ACL | 512 | 1 | 511| | IN-V6 ACL | 0 | 0 | 0| | IN-L2 ACL | 768 | 0 | 768| | OUT-L3 ACL | 158 | 5 | 153| | OUT-V6 ACL | 158 | 0 | 158| | OUT-L2 ACL | 206 | 7 | 199Codes: * - cam usage is above 90%.Dell#CAM OptimizationWhen you enable the CAM optimization, if a Policy Map containing classification rules (ACL and/or DSCP/ ip-precedence rules) is appliedto more than one physical interface on the same port-pipe, only a single copy of the policy is written (only one FP entry is used). When youdisable this command, the system behaves as described in this chapter.Troubleshoot CAM ProfilingThe following section describes CAM profiling troubleshooting.QoS CAM Region LimitationTo store QoS service policies, the default CAM profile allocates a partition within the IPv4Flow region.If the QoS CAM space is exceeded, a message similar to the following displays.%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3Cam(PolicyQos) for class 2 (Te 1/20) entries on portpipe 1 for linecard 1%EX2YD:12 %DIFFSERV-2-DSA_QOS_CAM_INSTALL_FAILED: Not enough space in L3 Cam(PolicyQos) for class 5 (Te 1/22) entries on portpipe 1 for linecard 1Content Addressable Memory (CAM) 239