Lead-In CharactersThe Lead-In Character commands must have a start and end code. Set 1 is thefactory default. Three sets (each containing a start and end code) are available:v Set 1: start code = <% (default)end code = >v Set 2: start code = ¬¬end code = $v Set 3: start code = _%end code = _v User DefinedUser Defined Codesv Start Code 2: X'5F' (the default)v Start Code 1: X'5F' (the default)v Stop Code: X'5B' (the default)The codes have a range of X'40' - X'FF'.Alternate Set 80 - 9FThis selection determines if ASCII codes X'80' through X'9F' will be used as controlcodes or printed as standard printable characters.v Printable (the default). Prints the alternate set as standard charactersv Control Code. Selects the alternate set to be used as printer control codes.Undefined Char ReportingUNDEFINED CHARACTER REPORTING allows overriding of the host setting ofthe SGEA (Set Graphic Error Action) command. For more information about theSGEA command, refer to the 6500 Coax/Twinax Programmer’s Reference Manual.v Enable (the default). The host setting for the SGEA and is used by the printer. Ifthe SGEA command is requested to stop on graphic errors, the printer will stopwhen a graphic error is detected.v Disable. Ignores the SGEA command from the host. The printer does not stopwhen an error is detected; instead, it substitutes the character selected in the“UNDEFINED CHARACTER SUBSTITUTION” menu entry.Chapter 4. The Configuration Menus 93
