Undefined Char SubUNDEFINED CHARACTER SUBSTITUTION specifies the replacement character toprint in place of any unprintable character that is received from the host. Thecharacter becomes the printer default when:v The printer is powered off and then powered on.v An SGEA command specifies to use the operator panel default.v The “UNDEFINED CHARACTER REPORTING” option is disabled.The character code point can be set to the following values:v X'60' (the default)v X'40' – X'FE' (HEX)Print Text DirectionSpecifies the direction in which text is printed on the page. This allows the printerto print languages which are printed right to left instead of left to right.v Left to Right (the default)v Right to Left. When a right to left language is selected, the host will be notifiedof print direction changes when the printer is put online.Override HostDetermines whether the printer executes certain commands sent by the host, orcontinues to use the current printer settings. The following host commands areignored when OVERRIDE HOST is enabled: line length, forms length, lines perinch (LPI), characters per inch (CPI), print quality, and text orientation (that is, leftto right). When OVERRIDE HOST is enabled, these settings retain their operatorpanel settings.Note: Host margin and tab settings will be used whether or not OVERRIDE HOSTis enabled.v Disable (the default). Allows certain host commands (line length, forms length,LPI, CPI, print quality, and text orientation) to override operator panel settings.Note that the information appearing on the message display may not match thedata stream setting. No values will change upon initial selection of the disableoption.v Enable. Permits operator panel settings to override host data stream commands.94 Infoprint 6500 User’s Manual
