Format ControlEnables the printer to reflect the same spacing as 6408/6412 Model CT0 printersafter absolute and relative move commands are executed. The following optionsare available:v Disable (the default) does not reflect distance, generated by the Code V feature,IGP feature, and Hex Transparent control code sequence, in the new position(after absolute and relative move commands are executed).v Enable. Reflects 6408/6412 Model CT0 distance, generated by the Code Vfeature, IGP feature, and Hex Transparent control code sequence, in the newposition (after absolute and relative move commands are executed).Maximum Printable WidthSets the maximum width of the printer when using a CT host interface.v 13.2 Inches (the default)v 13.6 InchesNote: The 5250 interface menu and 3270 interface menu option for maximumprintable width use the same internal variable. Setting this option in eithermenu will make it the current setting for the printer, independent of theinterface used.Although the LP+ emulation maintains width in characters, the maximumprintable width in characters is controlled by the same internal variable thatis set by the 5250 interface menu and 3270 interface menu option formaximum printable width option.C/T HotportGives the printer the ability to handle multiple data streams simultaneously. Itallows the printer to serve hosts attached to the serial, parallel, and either coax ortwinax ports as if they were the only interface connected.Port TypeSelects the type of port to be used. The Disable selection disables the port from thehotport process. The available selections are:v Twinax (the default)v Coaxv DisableNote: Changing the Port Type in this menu option also changes the Port Typesetting in the Coax Interface Menu.Chapter 4. The Configuration Menus 95
