TimeoutThis is the value used by the printer to time out from the current port and checkthe other ports for data to print. When the printer has not received data from thehost after the specified period of time, it needs to Timeout to service the otherports. The available selections are:v 15 Seconds (the default).v 10 to 180 Seconds.Report Statusv Disable (the default). A fault on the printer is reported only if it occurs on theactive port.v Enable. The faults are reported even if the fault is not on the current active port.Maximum Printable WidthSets the maximum width of the printer when using a CT host interface.v 13.2 Inches (the default)v 13.6 InchesNote: The 5250 interface menu and 3270 interface menu option for maximumprintable width use the same internal variable. Setting this option in eithermenu will make it the current setting for the printer, independent of theinterface used.Although the LP+ emulation maintains width in characters, the maximumprintable width in characters is controlled by the same internal variable thatis set by the 5250 interface menu and 3270 interface menu option formaximum printable width option.Chapter 4. The Configuration Menus 103
