Print LanguagePRINT LANGUAGE specifies the set of print languages used by the printer. Referto the previous page for print language menus.Specifying a print quality of OCR A or OCR B will change the print language toOCR A or OCR B.When OCR A or OCR B is selected as the default print language, OCR A and OCRB are the only available values for this print quality. If a different print qualityvalue is desired, the print language must be changed first.Print Character TablePRINT CHARACTER TABLE prints out a table of the 3270 interface currentcharacter set.Character sets are shown in the 6500 Coax/Twinax Programmer’s Reference ManualActive Print LanguageSelects which group of print language sets (standard or alternate) will be active.v Standard Print Language (the default)v Alternate Print LanguageEarly Print CompleteEarly print complete allows the printer to indicate to the host that print hascompleted before it actually occurs. This can improve throughput in certain modes.v Disable (the default). The printer will not respond until printing is complete.v Enable. The printer will indicate to the host that is is able to accept more databefore printing is complete.Note: Early Print Complete should only be enabled to improve performance whenrunning DSC (LU0) or DSE (LU3). This does not apply in SNA (LU1) mode.Interventions such as forms jams and end of forms will not be sent to thehost when Early Print Complete is enabled.Hex Transparent ControlYou can enable additional features that are not available in standard IBMemulations. To access these features, send lead-in character text commands in thedata stream. You can also use ASCII codes X'80' through X'9F' as control codes ifconfigured to do so.Chapter 4. The Configuration Menus 99
