Attaching Printer to zSeries SystemsIt is necessary to define a printer in the zSeries environment to VTAM*, JES2,POWER, PSF, VPS, JES328X Print Facility, NCP, VM, VSE, MVS, and/or othersoftware depending upon your operating environment and printing requirements.If you are attaching a printer with the IPDS feature installed, review the Infoprint6500 IPDS Programmer’s Reference Manual for information on configuring IPDS.Types of Installation covered for MVS/JES2Below is a list of configurations covered in this appendix:v LU1-SCS-Local SNA 3174 Control Unitv LU1-SCS-Remote SNA 3174 Control Unitv LU3-DSE-Local SNA 3174 Control Unitv LU3-DSE Remote SNA 3174 Control Unitv LU0-DSC-Local Non-SNA 3174 Control Unit6500-LU1-SCS-Local SNA 3174 Control UnitLU1-SCS mode is utilized when neither PSF support nor IPDS is required toaccomplish the print function desired. An existing local 3174 SNA-connectedcontrol unit is assumed. The steps required to install a local LU1-SCS printer forhost definitions are as follows:1. Define to VTAM ® by adding logmode entry to VTAM Logmode Table2. Define to JES2 (Not required but recommended. See the following details.3. Define to CICS* or another Application Program such as VPS or JES328Xproducts.4. Select the options on the printer that are appropriate for the environment.Step 1 - VTAM DefinitionThe following should be added to the Local Major Node VTAM definition. Theprinter will be attached as an LU1-IPDS capable printer.LOC3174V BUILD TYPE=LOCALLOCPU74 PU CUADDR=nnn...LOC6500 LULOCADDR=n,MODETAB=MYMODETB,DLOGMODE=6500SCSL,ISTATUS=ACTIVEAppendix D. Attaching Host Systems to a Coax/Twinax Printer 275
