Print QualityNote: When using bold or emphasized printing, the printer prints two dots insteadof one to produce the desired effect. This does not affect characters per inch.This parameter specifies the density (quality) of printing:v DP Quality (the default)v Near Letter Qualityv OCR Av OCR Bv Draftv NLQ Sans SerifNote: Receipt of a data stream control sequence that changes the print qualityoverrides the print quality specified via the operator panel.Specifying a print quality of OCR A or OCR B will change the print language toOCR A or OCR B.When OCR A or OCR B is selected as the default print language, OCR A/OCR Bare the only available values for this parameter. If a different print quality value isdesired, the print language must be changed first.Print Character TableThis parameter prints out a table of the current interface character set.Print AttributesThe PRINT ATTRIBUTES parameter is used to determine character and pageformatting.Proportional Spacing: Uses proportional spacing for text data when enabled.v Disable (the default)v Enable. Uses proportional spacing for text data.Note: Proportional spacing is only supported in 10 CPI. Therefore, you must select10 CPI, or proportional spacing will be ignored.Italic Print: Prints text in italics, when enabled. Both a forward and backwardsslanting italic are available.Disable (the default)Forward Slant. Uses italic print that slants forward.Backward Slant. Uses italic print that slants backward.Chapter 4. The Configuration Menus 197
