ASCII Data PortThis option sets the port number for ASCII print jobs. The data port number needsto match your host system setting.v 9100 (default)v 0 - 65535IPDS Data Port NumberThis option allows you to set the port number for IPDS print jobs. The portnumber needs to match your host system.v 5001 (the default)v 0 - 65535Keep Alive TimerThis is the time that the Keep Alive Timer will run. With the Keep Alive Timer on,the top connection will stay connected even after the print job has terminated.v 3 Minutes (default)v 2 - 10 MinutesEthernet SpeedThe Ethernet Speed menu allows compatibility with different systems andnetworks. The factory default is Auto Select.v Auto Select (the default). This setting tells the 10/100Base-T NIC to perform anauto detection scheme and configure itself to be 10 Half Duplex, 10 Full Duplex,100 Half Duplex, or 100 Full Duplex.v 10 Half Duplex. This setting tells the 100 Base-T NIC to communicate at 10Megabits per second using half duplex.v 10 Full Duplex. This setting tells the 100 Base-T NIC to communicate at 10Megabits per second using full duplex.v 100 Half Duplex. This setting tells the 100 Base-T NIC to communicate at 100Megabits per second using half duplex.v 100 Full Duplex. This setting tells the 100 Base-T NIC to communicate at 100Megabits per second using full duplex.Job ControlThe job control mode has three options:v Standard (default). The NIC waits for the printer to finish receiving the currentjob before sending another job. The status line shows “done” when the job iscompletely received by the NIC. This is the default.v Enhanced. The NIC waits for the printer to finish receiving the current jobbefore sending another job. The status line shows “done” when the job is fullyprinted.v Off. No job synchronization between the NIC and the printer.112 Infoprint 6500 User’s Manual
