Define LF CodeControls the action of the printer when it receives a Line Feed code (X'0A') fromthe host computer. If this feature is enabled, each time the printer receives a linefeed, it inserts an additional carriage return code (X'0D') into the data stream. Thisfeature can be used in most installations, but it is required if the host computerdoes not send carriage returns to the printer.v LF = CR + LF (the default). Adds an extra carriage return with each line feed.v LF = LF. Does not add a carriage return with a line feed.Character SetThis parameter selects a character set for the ANSI emulation. Note that when 0876OCR-A or 0877 OCR-B is selected as the print language, the Font AttributesTypeface parameter is changed to OCR-A or OCR-B, respectively. Character sets areshown in detail in the Character Sets Reference Manual.Printer Selectv ON = DC1/OFF = DC3 (the default). Disables the printer when a DC1 controlcode is received, and enables the printer when a DC3 control code is received.v Disable. Ignores the DC1 and DC3 control codes.ESC c Sequencev Enable (the default). An ESC c code received from the host resets the printerparameters to the factory defaults.v Disable. An ESC c code received from the host is ignored.Reset CommandWhen the printer receives a host data stream reset command (ESC @ or ESC[K) inaddition to resetting printer variables, the selected configuration will be loaded.v Disable (the default). The active emulation parameters are loaded when thereset command is executed.v Power-Up Config. The power-up configuration is loaded when the resetcommand is executed.v Current Config. The currently selected configuration is loaded when the resetcommand is executed.v Factory Config. The factory installed configuration is loaded when the resetcommand is executed.Received CRv Observe (the default). A CR code received from the host is handled as acarriage return.v Ignore. A CR code received from the host is ignored.Chapter 4. The Configuration Menus 159
