PA2PA2 is only valid when the printer is in the NOT READY state and the coax SCSdata stream is active. This function displays the “PA2 ENABLED” message whenthe Enter key is pressed and sends a special operator request to the host when theprinter is made READY.v Disable (the default)v EnableNote: Selecting the PA2 menu item again (“PA2 DISABLED” appears on theoperator panel) or selecting the PA1 menu item will reset the pending PA2function.Buffer ReprintThis option is only valid when the printer is in the NOT READY state and theCoax SCS data stream is active. The printer displays the “ENABLED” messagewhen the Enter key is pressed, and sends an Intervention Required Status to thehost when the printer goes to READY state.v Disable (the default)v EnableNote: Selecting the Buffer Reprint menu item again (“DISABLED” appears on theoperator panel) will reset the Buffer Reprint function.Early Print CompleteEarly Print Complete capability allows the printer to send Print Complete status tothe host before the printer is actually done printing all data.v Disable (the default). The printer will suppress the Early Print Completeresponse until all printing is complete.v Enable. The printer will send an acknowledgement to the host when it is able toaccept more data.Note: When an Early Print Complete is enabled and an error occurs, the data inthe printer will remain in the buffer (regardless of the setting of the CancelBuffer option). It is recommended that local procedures be followed torecover from the error.Do not select Early Print Complete while a print job is in progress. If this isdone you will need to restart the printer.80 Infoprint 6500 User’s Manual
