Received DELv Observe (the default). A DEL code received from the host is handled as a Deletecommand.v Ignore. A DEL code received from the host is ignored.Private ModeDetermines the default type of character set (Set 1 or Set 2). This can also be set byESC sequences ESC [>5h and ESC [>5l. Refer to these descriptions in the ANSIProgrammer’s Reference Manual for further details.v Set 2 (the default)v Set 1Pos. on BC/OvrSzv Set to Top (the default). The paper is fed back to the top of barcodes oroversized characters after they are printed. This allows printing on the sameline.v Set to Bottom . The printer will continue printing without backing up.BC Check Digitv By Host (the default). The host calculates the barcode check digit and sends italong with the barcode. The check digit is not verified by the printer but printedas it was received.v By Printer. The barcode is sent without the check digit, and the printercalculates and adds it in.Barcode Darkmodev Enable (the default). The barcodes are printed at a higher resolution.v Disable. The barcodes are printed at lower resolution but at a higher speed.PUM DefaultThis is the Unit of Measure (UOM) as it is used within the ANSI emulation.Coordinates received in ESC sequences can be sent in two UOMs: Decipoints,which is a unit of 1/720 inch, or in lines or columns using the current LPI and CPIvalues. The UOM used is determined by this configuration setting.v Decipoints (the default)v Lines/ColumnsTruncate PI Slewv Truncate at TOF (the default). The slew is terminated when the next Top-of-Form is reached. (This function applies to the ANSI EVFU only).v Disable. PI slews will be completed independent of their length.160 Infoprint 6500 User’s Manual
