Skip Command PrefixThis parameter determines if a data string before an IGP command will be ignored.v Enable (the default). The printer ignores all text before an IGP command.v Disable. The printer will print any data before an IGP command.Power On IGPYou can set the IGP feature so that it is enabled or disabled when the printer ispowered on.v Enable (the default). The IGP is enabled when the printer is powered on. (TheIGP feature is initialized in the Normal mode.)v Disable. The IGP is disabled when the printer is powered on. (The IGP featureis initialized to the Quiet mode.)Ext Execute Copyv Disable (the default). Dynamic data, overlay data, etc. are not allowed if theoptional Form Count parameter (number of forms to print) is specified as part ofthe Execute command. (This setting is IGP-100/200/400 compatible.)v Enable. Dynamic data, overlay data, etc. are allowed within a form in which theForm Count parameter is specified in the Execute command. In this case, theexact same form (with identical dynamic data, and so forth) is printed forwhatever the Form Count is. However, incremental data is not incriminatedsince the page that is printing is exactly the same. Also, each form is printed ona separate page.UPC DescendersThis parameter determines if a gap is left for human readable data in UPC/EANbar codes, even if there is no human readable data. There will be no change ifthere is human readable data.v Enable (the default). The IGP leaves a gap, even if there is no human readabledata.v Disable. The IGP does not leave a gap if there is no human readable data.Compressed CPIThis parameter allows you to choose a compressed character for CPI instead of thenormal height character.v Disable (the default). The IGP does not use the compressed CPI font.v Enable. The IGP uses the compressed CPI font.Chapter 4. The Configuration Menus 165
