Parallel HotportGives the printer the ability to handle multiple data streams simultaneously. Itallows the printer to service hosts attached to the serial, parallel, and either thecoax or twinax ports as if they were the only interface connected.Trickle TimeThis functionality prevents an attached host from timing out. In order to supportthis feature, the port has to be able to accept data from the host and store it forfuture use. The selected value is the time that the printer waits before getting thenext byte of data from the host. Set the value to be less than the host time outvalue. If the value is too much shorter, the printer fills up its buffer too fast. Thisfunction is not applicable for C/T hotport.v ¼ Sec (the default)v ½ Secv 1 Secv 2 Secv 4 Secv 8 Secv 16 Secv OFFTimeoutThis is the value used by the printer to time out from the current port and checkthe other ports for data to print. When the printer has not received data from thehost after a certain period of time, it needs to Timeout in order to service the otherports.v 10 Sec (the default)v 10 Sec - 60 SecReport StatusWhen this option is enabled, faults are reported even if the fault is not on thecurrent active port. If the option is disabled, a fault on the printer is reported onlyif it occurs on the active port.v Disable (the default)v Enable128 Infoprint 6500 User’s Manual
