Maximum Printable WidthMAXIMUM PRINTABLE WIDTH sets the maximum width of the printer whenusing a CT ® host interface.v 13.2 Inches (the default)v 13.6 InchesNote: The twinax interface menu and coax interface menu option for maximumprintable width use the same internal variable. Setting this option in eithermenu will make it the current setting for the printer, independent of theinterface used.Although the LP+ emulation maintains width in characters, the maximumprintable width in characters is controlled by the same internal variable thatis set by the twinax interface menu and coax interface menu option formaximum printable width option.Hex Print ModeWhen enabled, the HEX PRINT MODE parameter prints the EBCDIC data andcontrol codes received from the host as hex values.v Disable (the default)v EnableRefer to page 227 to obtain a hex code printout.Note: Printing in Hex Mode may alter print attributes set by the host computer. Apower cycle may be required after changing HEX PRINT MODE fromenable to disable.C/T HotportGives the printer the ability to handle multiple data streams simultaneously. Itallows the printer to serve hosts attached to the serial, parallel, and either coax ortwinax ports as if they were the only interface connected.Port TypeSelects the type of port to be used. The Disable selection disables the port from thehotport process. The available selections are:v Twinax (the default)v Coaxv DisableNote: Changing the Port Type in this menu option also changes the Port Typesetting in the Coax Interface Menu.Chapter 4. The Configuration Menus 75
