Follow these steps:1. Select a printer address from 0 through 6.2. From the printer operator panel Twinax Interface menu, make sure the printeraddress matches the printer address you selected from the table above. You canselect addresses ranging from 0 through 6; the default address is 1.3. If the IPDS feature is not installed, you must choose to emulate either a 5225 or4234-2 printer from the Twinax Interface menu, under Printer Emulation. Thedefault is 4234-2 printer emulation.4. If the IPDS feature is installed, you must choose to emulate a 4234-12, from theIPDS menu, under IPDS Emulation Mode. The default is 4234-12 printeremulation. See the IPDS Programmer’s Reference Manual for information on theIPDS Emulation Mode values.5. Turn printer off.6. Attach the twinax cable from your printer to your host workstation.7. Turn the printer back on. The iSeries’ auto configuration program will querythe printer and configure the host system software to recognize the printer.8. You may want to execute the iSeries Workstation Printer (VFYPRT) VerificationTest to make sure the iSeries host system recognizes the printer.Note: If you do not want to use the system printer configuration that is created bythe auto configuration program, you can change the printer configurationvalues as described in the following section.Changing Your iSeries Printer ConfigurationFor more information on configuring a printer, see iSeries Device Configuration Guideor the online configuration information on the system.Changing Configuration with Auto ConfigurationAuto Configuration can be utilized when either locally or remotely attaching to thesystem. The printer is configured as DEVTYPE (4234). Other parameters areautomatically assigned by the system. See the iSeries Device Configuration Guide formore information.272 Infoprint 6500 User’s Manual
