Print LanguagePRINT LANGUAGE specifies the set of print languages used by the printer. Referto the previous page for print language menus.v Standard Print Language (the default)v Alternate Print Language. Provides code pages compatible with 6408/6412Model CT0 printers. Use this option with the 3287 printer emulation.Specifying a print quality of OCR A or OCR B will change the print language toOCR A or OCR B.When OCR A or OCR B is selected as the default print language, OCR A and OCRB are the only available values for this parameter. If a different print quality valueis desired, the print language must be changed first.Print Character TablePRINT CHARACTER TABLE prints out a table of the coax interface currentcharacter set.All coax character sets are shown in the 6500 Coax/Twinax Programmer’s ReferenceManual.Active Print LanguageACTIVE PRINT LANGUAGE specifies which print language set will be the activeset.v Standard Print Language (the default)v Alternate Print LanguagePA1PA1 is only valid when the printer is in the NOT READY state and the coaxSystem Network Architecture Character Set (SCS) data stream is active. Thisfunction displays the “PA1 ENABLED” message when the Enter key is pressedand sends a special operator request to the host when the printer is made READY.v Disable (the default)v EnableRefer to the 6500 Coax/Twinax Programmer’s Reference Manual for more informationabout SCS.Note: Selecting the PA1 menu item again (“PA1 DISABLED” appears on theoperator panel) or selecting the PA2 menu item will reset the pending PA1function.Chapter 4. The Configuration Menus 79
